BLI H2a Coal Load Removal - Help!

NW Modeling List nw-modeling-list at nwhs.org
Sat Jun 6 10:35:23 EDT 2020


Matt,

I have several of the BLI H2a hoppers from various runs over the years.
Unless BLI changed the tooling, I was able to slip a small blade
screwdriver between the coal load and side of the car; then gently pried
the load up enough that I could then remove it.  Give it a try.

Jim Brewer

On Sat, Jun 6, 2020 at 10:15 AM NW Modeling List via NW-Modeling-List <
nw-modeling-list at nwhs.org> wrote:

> I’m getting ready to Dullcote a set of BLI H2a hoppers and cant figure out
> how to release the coal loads. I can rock them back and forth, pivoting on
> some unseen fulcrum in the middle of the car body. Stretching the sides and
> ends brings no joy.
>
> I suspect there is something easy that I’m missing. Any advice before I
> start cutting?
>
> Matt Goodman
> Columbus, Ohio
>
> Sent from my mobile
> ________________________________________
> NW-Modeling-List at nwhs.org
> To change your subscription go to
> http://list.nwhs.org/mailman/options/nw-modeling-list
> Browse the NW-Modeling-List archives at
> http://list.nwhs.org/pipermail/nw-modeling-list/
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://pairlist6.pair.net/pipermail/nw-modeling-list/attachments/20200606/06c18d12/attachment.html>


More information about the NW-Modeling-List mailing list