BLI H2a Coal Load Removal - Help!

[NW Modeling List]

Hi,

I just press on one end until it pops up on the other end.  When they are
new it's a little nerve wracking, but they pop out.

David Baker

On Sat, Jun 6, 2020, 10:15 AM NW Modeling List via NW-Modeling-List <
nw-modeling-list at nwhs.org> wrote:

> I’m getting ready to Dullcote a set of BLI H2a hoppers and cant figure out
> how to release the coal loads. I can rock them back and forth, pivoting on
> some unseen fulcrum in the middle of the car body. Stretching the sides and
> ends brings no joy.
>
> I suspect there is something easy that I’m missing. Any advice before I
> start cutting?
>
> Matt Goodman
> Columbus, Ohio
>
> Sent from my mobile
> ________________________________________
> NW-Modeling-List at nwhs.org
> To change your subscription go to
> http://list.nwhs.org/mailman/options/nw-modeling-list
> Browse the NW-Modeling-List archives at
> http://list.nwhs.org/pipermail/nw-modeling-list/
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://pairlist6.pair.net/pipermail/nw-modeling-list/attachments/20200606/db9bbbe5/attachment.html>