K-2 question

[NW Modeling List]

Harold
 
Hope you write up an article for the magazine detailing all that you are doing with this engine.
Sunset still has the drivers but at $150 a pop I will probably think about it for awhile.
Right now I don't even have track to run this thing!
 
Jim
 
 
-----Original Message-----
From: NW Modeling List <nw-modeling-list at nwhs.org>
To: NW Modeling List <nw-modeling-list at nwhs.org>
Sent: Fri, Mar 10, 2017 7:26 am
Subject: Re: K-2 question



Jim: I have installed the larger drivers on my K2 and he engine looks much better. Also I would like to install spoked pilot wheels but have not yet. The bell was not installed under the steps as on the model but on the pilot beam with a plain steel strap bracket.  However, if you keep the bell on the pilot beam you should not have spoked pilot wheels and will have to add the cooling grills to each side of the front cowling.  I plan to return the bell to the top of the boiler after I finish replacing the top of the skyline cowling which on my engine is miss-shaped .    


Harold Davenport 


  
 
 
  
 From: NW Modeling List via NW-Modeling-List <nw-modeling-list at nwhs.org>
 To: nw-modeling-list at nwhs.org 
Cc: NW Modeling List <nw-modeling-list at nwhs.org>
 Sent: Monday, March 6, 2017 1:10 PM
 Subject: Re: K-2 question
  
 



Jimmy
 
I'll have to take another look at it. Wonder if anyone has installed the replacement drivers that Sunset offered some time back?
Also it would be neat to install spoked lead truck wheels.
 
Jim Kehn
 
 
-----Original Message-----
From: NW Modeling List <nw-modeling-list at nwhs.org>
To: NW Modeling List <nw-modeling-list at nwhs.org>
Sent: Mon, Mar 6, 2017 8:34 am
Subject: Re: K-2 question



    
On 3/5/2017 1:09 PM, NW Modeling List via NW-Modeling-List wrote:
    
    
I decided to        leave the bell under the pilot but may substitute a smaller bell        or reposition it. Looking at the top it would be a pain to try        and put it there,
    
    Jim,
        It wouldn't be hard to put the bell up on top as the area up    there is wide open. You just need the correct part from PSC.
    
    Jimmy Lisle
  

________________________________________
NW-Modeling-List at nwhs.org
To change your subscription go to
http://list.nwhs.org/mailman/options/nw-modeling-list
Browse the NW-Modeling-List archives at
http://list.nwhs.org/pipermail/nw-modeling-list/



________________________________________
NW-Modeling-List at nwhs.org
To change your subscription go to
http://list.nwhs.org/mailman/options/nw-modeling-list
Browse the NW-Modeling-List archives at
http://list.nwhs.org/pipermail/nw-modeling-list/



 
 
  

________________________________________
NW-Modeling-List at nwhs.org
To change your subscription go to
http://list.nwhs.org/mailman/options/nw-modeling-list
Browse the NW-Modeling-List archives at
http://list.nwhs.org/pipermail/nw-modeling-list/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://pairlist6.pair.net/pipermail/nw-modeling-list/attachments/20170310/1f29ff84/attachment-0001.html>