Homasote vs pink foam board

[NW Modeling List]

Blue Points (IMO) have a better feel and a much shorter throw (~3/16" vs 1"). Bullfrogs are less expensive, have a somewhat lower profile, and a much more positive throw (longer throw and thicker wire). Some photos of my experimentation with both (and relevant comments) are at the link below. 

http://goodman312.zenfolio.com/p802892396/e2AEF21BC

Matt Goodman
Columbus, Ohio

Sent from my mobile

On May 6, 2014, at 3:06 PM, NW Modeling List <nw-modeling-list at nwhs.org> wrote:

Hi modelers,
 
                After being away from layout building for 20 years I’m ready to get back in.  I’m looking for advice on whether to use Hoamsote or pink foam board.
 
                I bought Seivers 48” modules in 16” and 18” widths.  Either way I’m planning on using a ¼” plywood layer.  If I go with the foam should I use the 1” or the 2” foam?  The layout is in a bedroom here in Southern California so it doesn’t get under 65* and rarely over 95*.  I’m using the plywood for mounting the turnout controllers.
 
                While on the subject of turnout controllers I’m having a time deciding on either the PPW/Aline “Blue Point’s” or Fast Traxx Bullfrog’s.  Any pros or cons on either?
 
Thank you in advance,
John Hecker
 
________________________________________
NW-Modeling-List at nwhs.org
To change your subscription go to
http://list.nwhs.org/mailman/options/nw-modeling-list
Browse the NW-Modeling-List archives at
http://list.nwhs.org/pipermail/nw-modeling-list/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://six.pairlist.net/pipermail/nw-modeling-list/attachments/20140508/c9d7b705/attachment-0001.htm>