Bachmann J HO Loco

[NW Modeling List]

Hello Barry,

 

It takes 3 screws to remove the shell from the Spectrum J.  One is in the front of the engine just over top of the leading axle on the pilot truck on the bottom side of the model.  You should be able to turn the pilot truck sideways and reach the screw with a medium sized jewelers phillips head screwdriver.  The 2 screws in the back are a little more tricky.  These 2 screws go in through the frame into the back outer corners of the cab underneath the model.  There is a plastic fixture on each side of the loco under the cab that friction fits into the side of the frame.  The feedwater lines come out of the shell behind the rear driver set and run into these fixtures under the cab.  These 2 plastic castings must be pried off with a small flathead screwdriver to reveal the screws beneath the cab.  The feedwater lines pivot on these fixtures, so as long as your not too rough, once you pry these two plastic casting off you should be able to pivot them away from the cab enough to reach the screws.  Hope this helps.

 

Thanks,

Chris Dalton

Bluefield, WV







   

 

 

 

 








 		 	   		  
_________________________________________________________________
Hotmail: Free, trusted and rich email service.
http://clk.atdmt.com/GBL/go/171222984/direct/01/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://six.pairlist.net/pipermail/nw-modeling-list/attachments/20091011/35a35fd2/attachment.htm>