Scratch building

[NW Modeling List]

I do not have a drill press, but I have successfully used the Micro Mark corner punch with a hammer.  It is a very good tool for punching window corners in styrene. You  need to cut between the punched corners with a very sharp X-Acto knife.

 

 

Paul Mandelkern

Winter Park, Florida

 

From: NW-Modeling-List <nw-modeling-list-bounces at nwhs.org> On Behalf Of NW Modeling List via NW-Modeling-List
Sent: Thursday, March 26, 2020 10:16 AM
To: nw-modeling-list at nwhs.org
Cc: NW Modeling List <nw-modeling-list at nwhs.org>
Subject: Re: Scratch building

 

Micromark tools seels a square chisel that mount in a drill press that makes cutting windows a breeze! Check it out!

https://www.micromark.com/3-16-Inch-Corner-Punch

Ray Russell Sr.

In a message dated 3/26/2020 6:37:50 AM Eastern Standard Time, nw-modeling-list at nwhs.org <mailto:nw-modeling-list at nwhs.org>  writes: 

 

I



-- 
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://pairlist6.pair.net/pipermail/nw-modeling-list/attachments/20200326/e6fe7afc/attachment.html>