PCM Y6b question

[nw-modeling-list at nwhs.org]

Thank you all for the info on the cab signal box.

Any ideas on the steam and signal lines?

John Rhodes


On 5/29/06, nw-modeling-list at nwhs.org <nw-modeling-list at nwhs.org> wrote:

>

>  The cab signals would have been on all the Roanoke Terminal Y6s -

> 2120-2180 except 2162.  I don't know if any of the higher-numbered Y-6bs had

> them or not, off hand.  The 2162 was the only Y-6a not assigned to Shaffers

> Crossing for maintenance - it was assigned to Bluefield like the 2181-2200.

>

> EdKing

>

>  ----- Original Message -----

> *From:* nw-modeling-list at nwhs.org

> *To:* nw-modeling-list at nwhs.org

> *Sent:* Monday, May 29, 2006 2:15 AM

> *Subject:* Re: PCM Y6b question

>

>

>  In a message dated 5/28/2006 6:55:35 AM Eastern Standard Time,

> nw-modeling-list at nwhs.org writes:

>

> On most Y6's pictures I have seen, on the engineer's side there is a "box"

> where the running board steps up, over the front engine near where the front

> tube sheet would be.  This is missing on the PCM model.  What is this device

> and did all Y6's have them?

>

>  That would be the cab signal box. They were put on engines used on the

> Shenandoah Div. Not all of the engines had them.

> Jimmy Lisle

>

> ------------------------------

>

> ________________________________________

> NW-Modeling-List at nwhs.org

> To change your subscription go to

> http://list.nwhs.org/mailman/options/nw-modeling-list

>

>

> ________________________________________

> NW-Modeling-List at nwhs.org

> To change your subscription go to

> http://list.nwhs.org/mailman/options/nw-modeling-list

>

>

>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://six.pairlist.net/pipermail/nw-modeling-list/attachments/20060531/af17baee/attachment.html